Monitors the status of cluster management connectivity between the command switch and a cluster member in Cisco switches.
SNMP should be enabled in end device and device should support CISCO-CLUSTER-MIB OIDs and SNMP credentials should be attached against the device in portal.
How to Apply: This template is All instance selection based. It will not ask user to select any instance (s) while assigning it to a device.
|Warning Threshold||If the metric value satisfies the condition defined along with Warning Threshold value, then a notification is sent to the user.|
|Critical Threshold||If the metric value satisfies the condition defined along with Critical Threshold value, then a notification is sent to the user.|
|Alert||The alert value can be set to either Yes or No. If it is Yes, then an alert message is sent to the user.|
|Description||Monitors the status of cluster management connectivity between the command switch and a cluster member. Cluster management connectivity is determined by the exchange of cluster management messages between the command switch and a cluster member. A member that has failed to exchange cluster management messages with the command switch is deemed to be inactive. Otherwise, it is deemed to be active. Possible Values are 1- active, 2- inactive.|
[OIDs: 220.127.116.11.18.104.22.168.22.214.171.124.1.2, 126.96.36.199.188.8.131.52.184.108.40.206.1.3]
|Monitor Name||Cisco Switch Cluster Status|
|Metric||Input Value||Range of Values|
|Frequency||15||1 – 1440 (mins)|
|Warning Repeat Count|
|Critical Operator||EQUAL||Ends with, ==, !=, >=, <=, >, <, In Range, Out of range, Equals, Not equals, Equals Ignore Case, Not Equals Ignore Case, Contains, Not contains, Regex match, Regex no match, In string list, Not in string list, In List, Not in list, Starts with|
|Critical Repeat Count||1||1-12|