Description
Device must support the AIRESPACE-WIRELESS-MIB and VG v2.70 or above. Monitors the connectivity status of the Cisco WLAN Controller AP. This template will be supported by VG v2.70 or above [AIRESPACE-WIRELESS-MIB.mib].
Prerequisites
SNMP should be enabled in end device and device should support AIRESPACE-WIRELESS-MIB OIDs and SNMP credentials should be attached against the device in portal.
Metric Parameters
| Parameter | Description |
|---|---|
| Frequency | |
| Warning Threshold | If the metric value satisfies the condition defined along with Warning Threshold value, then a notification is sent to the user. |
| Critical Threshold | If the metric value satisfies the condition defined along with Critical Threshold value, then a notification is sent to the user. |
| Alert | The alert value can be set to either Yes or No. If it is Yes, then an alert message is sent to the user. |
Metrics
cisco.wlan.ap.status
Metric Details
| Applicable for | Device |
| SNMP OID | NULL |
| Expression | NULL |
| Description | Monitors the connectivity status of AP to the Cisco WLAN Controller. Possible values are - 1 (Connected) and 2 (Disconnected). [OIDs: 1.3.6.1.4.1.14179.2.2.1.1.3, 1.3.6.1.4.1.14179.2.2.1.1.19, 1.3.6.1.4.1.14179.2.2.1.1.33] |
| Category | SNMP monitors |
| Collector Type | Gateway |
| Monitor Name | Cisco WLAN Controller AP Status |
| Unit |
Possible Inputs
| Metric | Input Value | Range of Values |
|---|---|---|
| Frequency | 5 | 1 – 1440 (mins) |
| Filter | ||
| Warning Operator | ||
| Warning Threshold | ||
| Warning Repeat Count | ||
| Critical Operator | EQUAL | Ends with, ==, !=, >=, <=, >, <, In Range, Out of range, Equals, Not equals, Equals Ignore Case, Not Equals Ignore Case, Contains, Not contains, Regex match, Regex no match, In string list, Not in string list, In List, Not in list, Starts with |
| Critical Threshold | 2 | 1, 2 |
| Critical Repeat Count | 1 | 1-12 |
| Alert | Yes | Yes/No |
| Graph (Yes/No) | Yes | Yes/No |
Sample Output
