Description
Monitors the elapsed time(seconds) from the Chassis Bootup Time. i.e., System uptime. It is supported by VG v2.7.0 and above. [OID: 1.3.6.1.4.1.6027.3.6.1.1.1.0]
Prerequisites
SNMP should be enabled in end device and device should support f10-trap-alarm MIB OIDs and SNMP credentials should be attached against the device in portal.
Metric Parameters
| Parameter | Description |
|---|---|
| Frequency | Warning Threshold | If the metric value satisfies the condition defined along with Warning Threshold value, then a notification is sent to the user. |
| Critical Threshold | If the metric value satisfies the condition defined along with Critical Threshold value, then a notification is sent to the user. |
| Alert | The alert value can be set to either Yes or No. If it is Yes, then an alert message is sent to the user. |
Metrics
dell.force10.system.uptime
Metric Details
| Applicable for | Device |
| SNMP OID | 1.3.6.1.4.1.6027.3.6.1.1.1.0 |
| Expression | ELAPSE_TIME_FOR_DATEANDTIME(f10ChassisBootupTime) |
| Description | Monitors the elapsed time (seconds) from the Chassis Bootup Time. i.e., System uptime. [OID: 1.3.6.1.4.1.6027.3.6.1.1.1.0] |
| Category | SNMP monitors |
| Collector Type | Gateway |
| Monitor Name | Dell Force10 System Uptime |
| Unit | s |
Possible Inputs
| Metric | Input Value | Range of Values |
|---|---|---|
| Frequency | 5 | 1 – 1440 (mins) |
| Filter | ||
| Warning Operator | ||
| Warning Threshold | ||
| Warning Repeat Count | ||
| Critical Operator | LESS_THAN_EQUAL | Ends with, ==, !=, >=, <=, >, <, In Range, Out of range, Equals, Not equals, Equals Ignore Case, Not Equals Ignore Case, Contains, Not contains, Regex match, Regex no match, In string list, Not in string list, In List, Not in list, Starts with |
| Critical Threshold | 1800 | 0 - 4294967295 |
| Critical Repeat Count | 1 | 1-12 |
| Alert | Yes | Yes/No |
| Graph (Yes/No) | Yes | Yes/No |
Sample Output
