Description
Template to monitor Juniper VPN Phase 1 (IKE) tunnel peer status. Validated on SRX Firewall, SysObjId is 1.3.6.1.4.1.2636.1.1.1.2.35 [JUNIPER-IPSEC-FLOW-MON-MIB::jnxIkeTunMonState - 1.3.6.1.4.1.2636.3.52.1.1.2.1.6]
Prerequisites
SNMP should be enabled in end device and device should support JUNIPER-IPSEC-FLOW-MON-MIB OIDs and SNMP credentials should be attached against the device in portal.
How to Apply: This template will ask user for 2 input parameters while assigning it to a device –
Remote Peer Identity
The IP address of the remote peer identity.
Example 1: 66.100.189.125
VPN Name
Example: VPN-datacenter.
Metric Parameters
Parameter | Description |
---|---|
Frequency | Warning Threshold | If the metric value satisfies the condition defined along with Warning Threshold value, then a notification is sent to the user. |
Critical Threshold | If the metric value satisfies the condition defined along with Critical Threshold value, then a notification is sent to the user. |
Alert | The alert value can be set to either Yes or No. If it is Yes, then an alert message is sent to the user. |
Metrics
juniper.vpn.ike.tunnel.status
Metric Details
Applicable for | Device |
SNMP OID | NULL |
Expression | NULL |
Description | Monitors the Juniper VPN Phase-1 (IKE) Tunnel Status. [OID: 1.3.6.1.4.1.2636.3.52.1.1.2.1.6] |
Category | SNMP monitors |
Collector Type | Gateway |
Monitor Name | Juniper VPN Phase 1 (IKE) Tunnel Status |
Unit |
Possible Inputs
Metric | Input Value | Range of Values |
---|---|---|
Frequency | 5 | 1 – 1440 (mins) |
Filter | ||
Warning Operator | ||
Warning Threshold | ||
Warning Repeat Count | ||
Critical Operator | EQUAL | Ends with, ==, !=, >=, <=, >, <, In Range, Out of range, Equals, Not equals, Equals Ignore Case, Not Equals Ignore Case, Contains, Not contains, Regex match, Regex no match, In string list, Not in string list, In List, Not in list, Starts with |
Critical Threshold | 2 | [{"1":"Up"},{"2":"Down"}] |
Critical Repeat Count | 1 | 1-12 |
Alert | Yes | Yes/No |
Graph (Yes/No) | Yes | Yes/No |
Sample Output
No graph